Supply and Install

• Scraper floor wear plate, 60×6 flat 6m lengths site welded to a 200×6 flat bar which is welded to D10 studs chemset into concrete.
• Scraper angle wall mounts
• Scraper angle guide 75×10 EA 9m lengths 10.5kg/m

• Scraper drives and motors new mounting plates
• Scraper slipper plates
• Electrical connections

Installation of PNCC Supplied equipment including:

• 1650 ft of Scraper chain (550ft per tank) CS720S conveyor pintle chain
• 156 x Scraper chain mount brackets, CS720S conveyor chain – F226 attachment
• 12 x Scraper chain swing mount brackets, CS720S conveyor chain – PDF22-6 hinged attachment base
• 12 x Scraper chain hinged attachment, CS720S conveyor chain – M1 hinged attachment
• 6 x Scraper Bottom idler sprocket, 19t 720S chain sprocket with C type hunting tooth with 4″ bore
• 6 x Scraper End idler sprocket, 23t 720S chain sprocket with C type hunting tooth with 4″ bore
• 6 x Scraper Top Drive sprocket, 19t 720S chain sprocket with C type hunting tooth with 4.5″ bore

• Drive Shaft rebuild + replace bearings and housing (Allows to reuse existing shaft, assumes no shaft build up required)
• Bottom idler shaft rebuild + replace bearings and housing (Allows to reuse existing shaft, assumes no shaft build up required)
• End idler shaft rebuild + replace bearings and housing (Allows to reuse existing shaft, assumes no shaft build up required)

• 60 ft of Drive Chain, 20ft per tank of 4103, 3.075” pitch pintle chain
• 3 x Drive chain drive sprocket, 10t 4103 chain 4.5″ bore
• 3 x Drive chain driven sprocket, 40t 4103 chain 4.5″ bore (Split sprocket with 6.5” hub offset)
• 3 x Drive chain idler sprocket 7t 4103 chain 4.5″ bore
• 6 x Wall bearing assembly, 4” split cast iron top load with UHMWPE bearing
• 6 x Wall bearing assembly, 4.5” split cast iron top load with UHMWPE bearing
• 6 x Wall bearing assembly, 4” split cast iron bottom load with UHMWPE bearing
• Scraper drives and motors
• Existing timber scraper flights (Scraper Boards)

Cross Collector System

Supply and Install

• Auger
• End bearings and housings
• Electrical connections

Install Only

• Drive chain, 40 ft per tank, WH78 chain
• Drive sprocket, 10t WH78 chain, 3” bore
• Drive sprocket, 19t WH78 chain, 3” bore
• Motors and drives
• Cross collector drive and motor, new mounting plate